•PHY settings (speed and duplex mode of the either LAN or PC port are restored to "automatic")
•VLAN settings (disabled)
•Terminal number settings (restored to "automatic")
To perform IP Reset
In cases when buttons/soft key icons are shown in English alphabet
1. Base unit: [MENU] (middle soft key) ® [#][7][3][0]
Handset: [MENU] (center of joystick) ® [#][7][3][0]
2. []/[ ]: Select "Yes" ® [SELECT]
The settings are returned to their factory defaults, and the base unit will restart.
In cases when buttons/soft key icons are shown in symbols/pictures
1. Base unit: (middle soft key) ® [#][7][3][0]
Handset: (center of joystick) ® [#][7][3][0]
2. [ ]/[ ]: Select "Yes" ®
The settings are returned to their factory defaults, and the base unit will restart.
Notice
•Once you press [#][7][3][0], IP Reset is performed immediately and without asking for confirmation,
regardless of the communication status. As a result, the base unit is disconnected from the IP network
immediately.
Note
•If these settings (with the exception of PHY settings and terminal number settings) were made through
Web user interface programming, the set values made through Web user interface programming
remain effective, even if you perform IP Reset. To reset these settings to their factory defaults, perform
Reset Web Settings from the Web user interface again.
•If these settings (with the exception of PHY settings and terminal number settings) were made through
configuration file programming, the set values made through configuration file programming remain
effective, even if you perform Reset Web Settings.
2.1.5 Terminal Number Settings
You can select the terminal number of the unit that you are using from "Terminal 1"–"Terminal 9",
and "Auto". The default setting is "Auto". "Auto" does not assign a fixed terminal number to the unit.
If multiple units try to access the same router simultaneously, errors can occur. Assigning a terminal number
1 to 9 to each of the units may prevent such errors.
To assign a terminal number to the unit
In cases when buttons/soft key icons are shown in English alphabet
1. Base unit: [MENU] (middle soft key) ® [#][7][3][1]
Handset: [MENU] (center of joystick) ® [#][7][3][1]
2. []/[ ]: Select the desired terminal number ("Auto", "Terminal 1"–"Terminal 9") ® [SAVE]
3. Base unit: [EXIT]
Handset: [OFF]
In cases when buttons/soft key icons are shown in symbols/pictures
1. Base unit: (middle soft key) ® [#][7][3][1]
Handset: (center of joystick) ® [#][7][3][1]
Document Version 2010.03.15 Administrator Guide 37
2.1.5 Terminal Number Settings