Panasonic NV-DV2000EC operating instructions Connecting with a Panasonic Digital Video Camera

Connecting with a Panasonic Digital Video Camera

Example for connecting Panasonic NV-DS25 Digital Video Camera as the playback unit, when controlling the playback unit through the NV-DV2000.

AV1 (Rear)

Recording Unit

Playback Unit

¥ DV2	DV SELECT		EDIT	8mm
	1
	2
AV4					RECORDER	EDIIT CONTROL
					PLAYER	PASSIIVE DV EDIT 8mm
IN
S-VIDEO		VIDEO	L/MONO-AUDIO-R		PRIINTER//
					D..STIILL PIICTURE

Notes:

≥Before connecting any cables, first make sure that the power for both units is off.

≥Insert a recorded cassette into the playback unit, and a cassette with the closed record prevention tab into the VCR.

≥If the playback unit is connected to the recording unit via an S-VIDEOcable, the video signal on the S-VIDEOcable takes priority. If the playback unit does not have an S-VIDEOsocket, do not connect the S-VIDEOcable to the NV-DV2000.

≥Use of an AC adaptor as the power source for the Digital Video Camera is recommended. Doing so avoids a situation where the camera shuts down due to low battery power.

≥It is recommended that the DV cable be disconnected for editing with INPUT SELECT set to A1-A4. If INPUT SELECT is set to A1-A4 with the connections shown in the figure left unchanged, the TV picture may be disturbed or noise may occur. (This has no effect on the actual editing operations.)

≥When the units are connected using the DV cable and editing is performed, some editing functions will differ compared with when the units are connected using the AV cables. Refer to Glossary of Terms on [R58].

≥Read the operating instructions of the Digital Video movie Camera.

≥Do not change the Edit Terminal or Edit Mode settings while performing setting or editing operations at the SET UP or EDIT MENU screens. Be sure to quit these screens before changing these settings.

28