To continue setting programmes:
1Press EDIT MENU.
2Press PLAYER.
3Using 21 (CURSOR), select the programme number.
The programme number changes each time these buttons are pressed.
(Up to 20 programmes can be set.
10 programmes can be set on one page; if this number is exceeded, the display automatically changes to the next page.)
4Repeat steps
Notes:
≥ Programme Editing can be performed using either the |
tape counter or Time code display, but the Time code |
display should be used if the units are connected only |
by a DV cable. |
≥ If you attempt to switch to the tape counter display in |
order to perform editing after setting the editing points |
using the Time code display, the Erase all |
programmes screen is displayed. |
(The Erase all programmes screen is also displayed |
when you change from the tape counter display to the |
Time code display.) |
≥ After setting a programme, if you attempt to set |
another programme in a different editing operation, |
10Press 34 (CURSOR) to select Start Assemble to start editing, and then press OK.
≥Editing begins after the playback unit and the recording VCR both rewind their tapes to the edit start points.
11After completing editing, press 34(CURSOR) to select Review, and then press OK.
≥The edited pictures are played back.
Assemble
Confirm/Change
Insert a programme
Erase a programme
Preview
Start Assemble
Review
Timing Adjust
A s s e m bl e
[Page1]
1
1 PLAYER | RECORDER ¥ |
Assemble in Progress
Assemble
Confirm/Change
Insert a programme
Erase a programme
Preview
Start Assemble
Review
Timing Adjust
the set contents for the previous editing operation |
remain on the setting screen. In order to prevent |
editing errors, perform the Erase all programmes |
operation [R53] whenever you set a programme |
under a different editing mode. |
≥ Programme editing can not be performed with a video |
movie camera that has a |
≥ Although Assemble editing can be performed in LP |
mode, Insert, Audio Dubbing, and Audio Mixing |
cannot be performed with a tape recorded in LP |
mode. It is necessary to first copy the tape in SP |
mode. |
≥ In order to ensure that the editing operation is |
performed properly, the editing points should be set at |
least 20 seconds after the beginning of the tape. |
≥ The editing operation may not be performed correctly |
if the set duration of a programme is less than |
4 seconds. |
≥ On a video equipment whose Time code display or |
tape counter display does not show the frame value, |
the area where the frame value is displayed appears |
Editing
To interrupt editing or Review:
Press EDIT MENU.
as “00f” or it remains blank. |
With some units, the frame value may be displayed |
when MARK IN or MARK OUT is pressed in steps |
5 and 6 even if the unit concerned does not show the |
frame value. |
≥ The Preview function cannot be used with the |
Assemble function. |
≥ Up to n1 second of slight deviation in the specified |
edit start/end position can be corrected. See [R54] |
for Edit Timing Adjustment. |
Programme
47
