Panasonic PT-L595U Switching the signal mode during RGB signal input, Signal data No. of dots

<Switching the signal mode during RGB signal input>

If the picture is not projected normally when the selected input source is “RGB 1” or “RGB 2” because the signal mode selected does not match, select the correct signal mode by the procedure given below. The factory pre- setting is “AUTO”, so the projector can usually be used without the need to change this setting.

Setting procedure

1.Press the MENU button to display the MENU screen.

2.Press the “ ” and “ ” buttons to select “PICTURE”.

3.Press the “<” and “>” buttons to display the PICTURE screen.

4.Press the “ ” and “ ” buttons to select “SIGNAL MODE”.

5.Press the “<” and “>” buttons to switch the signal name.

Refer to the table below when switching to the matching signal mode.

Display mode name			Signal data
	No. of dots		Horizontal scanning frequency (kHz)	Vertical scanning frequency (Hz)
AUTO	Automatically switches to whichever of the following signal modes best matches the input signal
VGA 400	640	× 400	31.5	70.0
VGA 480	640	× 480	31.5	60.0
MAC 13	640	× 480	35.0	66.7
PC 98	640	× 400	24.8	56.4
VESA	640 × 480		37.9	72.8
S-VGA 1	800	× 600	35.2	56.3
S-VGA 2	800 × 600		37.9	60.4
S-VGA 3	800 × 600		46.9	75.0
S-VGA 4	800 × 600		48.1	72.0
S-VGA 5	800 × 600		32.1	51 .0
MAC 16	832 × 624		49.7	74.6
XGA 1	1024 × 768		48.4	60.0
XGA 2	1 0 2	4 × 6 8	56.4	70.0
XGA 3	1024 × 768		68.7	85.0
MAC 19	1024 × 768		60.2	75.0

NOTE:

The display resolution for the PT-L595U projector is 800 × 600 dots. If any of the above signals which have resolutions greater than this are input, the resolution will be converted to 800 × 600 dots.

The setting screen and the MENU screen can both be cleared by pressing the MENU button.

19