Panasonic PT-L595U manual Example of connection to a computer, Sub Hd

Example of connection to a computer

			Pin configuration and signal
			names for RGB connector
Computer	Monitor	Audio system	5	1
			10	6
			15	11

	To video
	input
	connector
To audio	Macintosh adapter
output
	(accessory)
terminal
	D-SUB HD 15-pin
To video
	(male)
output
	D-SUB HD
connector
	15-pin (male)

Pin No.	Signal name
1	R
2	G/G-SYNC
3	B
9	NC
12	SDA
13	HD/SYNC
14	VD
15	SCL
4-8,10, and 11	GND

NOTE:

Pin No. 12 and pin No. 15 on 15-pin connectors will only work if the computer supports them.

D-SUB HD 15-pin		Computer for
(male)		control use
VGA cable
(accessory)		D-SUB
Computer
	13-pin	9-pin
To video		(female)
	(male)
output
connector
	To audio output terminal	Mouse cable for PS/2
		(accessory)
	To mouse connector

NOTE:

If the mouse connector on the projector is connected to the mouse connector on the computer with the accessory or separate mouse cable, you can then use the remote control unit in place of the computer’s mouse. However, this function operates only when input to the RGB 1 connector has been selected. For further details, refer to page 35.

If you wish to use the infrared mouse function, turn on the main power to the projector before turning on the personal computer.

If using a personal computer with a suspend/resume function, the infrared mouse function may not operate until the computer is restarted.

Refer to the data on page 19 for details of what kinds of computers can be connected to the projector. If computers other than those listed here are used, correct operation cannot be guaranteed.

The signal which is connected to the RGB IN connector for RGB 1 or RGB 2 will be output from the RGB OUT terminal. However, no signal is output from the RGB OUT terminal if the input signal is switched so that RGB 1 and RGB 2 are no longer selected, or if the projector power is turned off.

34