Panasonic PT-L595U manual Adjusting the volume

Adjusting the volume

The volume can be adjusted by pressing the VOL (+/-) buttons on the remote control unit.

Remote control unit

Turning off the sound

If the “+” button is pressed, the volume will increase, and if the “-” button is pressed, the volume will decrease.

NOTE:

If these buttons are pressed while the on-screen display for another function is currently on the screen, the volume will still be adjusted but the current volume setting and the volume bar display will not appear.

The volume can also be adjusted from an on-screen display menu. Refer to page 24 for details on how to do this.

The volume output level will remain displayed on the screen for approximately three seconds.

If the MUTE button on the remote control unit is pressed, “MUTE” will be displayed on the screen as shown in the illustration below and the sound will be muted. If the MUTE button is pressed once more, the on-screen display will be cleared and the normal sound volume will be restored. The volume output level will remain displayed on the screen for approximately three seconds.

Remote control unit	NOTE:
	If the MUTE button is pressed while the on-screen display
	for another function is currently on the screen, the volume
	will still be muted but the “MUTE” on-screen display will not
	appear.
	If the power supply is turned off or either of the VOL (+/-)
	buttons is pressed, the mute setting will be canceled.
	It is also possible to have the picture turn off together with
	the sound when the MUTE button is pressed. Refer to page
	32 for details on how to change this setting.
	When the picture has been turned off in this way, the words
	“PICTURE MUTE” will be displayed on the screen.

Resetting adjustment values to the factory pre-settings (standard values)

If the STD (Standard) button on the remote control unit is pressed while the PICTURE screen, POSITION screen, AUDIO screen or one of the individual adjustment screens is being displayed, the adjustment settings being displayed will be reset to the factory pre-settings.

Remote control unit	If the STD (Standard) button on the remote control unit is
	pressed while the PICTURE screen, POSITION screen or
	AUDIO screen is being displayed, the letters “STD” will be
	displayed in yellow in the top-right corner of the screen and
	all items displayed will be reset to the factory pre-settings.
	NOTE:
	However, the “TV-SYSTEM” and “ SIGNAL MODE” settings
	in the PICTURE screen and the “VOLUME” setting in the
	AUDIO screen will not return to the factory pre-settings.
	If the STD (Standard) button on the remote control unit is
	pressed while one of the individual adjustment screens is
	being displayed, the value and the bar display will be
	appeared in yellow and only the item displayed will be reset
	to the factory pre-setting.

21