Setup 1 Charging
Insert the battery into the unit and charge it.
1 Set the mode dial to [OFF].
The unit runs on AC power (status indicator lit red) and the battery cannot be charged when the mode dial is set to any position other than [OFF].
2 Opendoor. the card/battery
Open the door by sliding the card/ battery door lever to the “OPEN” position.
3 Insert the battery.
Ensure that battery is oriented correctly, and push it into the compartment in the direction of the [▲] until it snaps into place and it is locked by the lever.
(To remove the battery, press the lever in the direction of the [
].)
Lever
4 Closedoor. the card/battery
Close the card/battery door and slide the card/battery door lever to the “LOCK” position.
5 Connect the AC adaptor (supplied).
Connect the AC cable to the AC adaptor and then to an AC outlet.
●Use only the AC adaptor supplied with the unit.
To AC outlet 
AC adaptor
AC cable＊
Small gap here.
＊Do not use the AC cable and AC adaptor of this unit with other devices. Also, do not use the AC cables and AC adaptors of other devices with this unit.
20 LSQT1426
