Installation

Receiver Location

Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the screen.

Use of some types of fluorescent lighting can reduce remote control transmitter range.

Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or moisture.

To insure optimum color purity do not position magnetic equipment (motors, fan, other speakers, etc.) nearby.

Optional External Equipment Connections

The Video/Audio connections between components can be made with shielded video and audio cables. For best perfor- mance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic supply house.

Before you purchase any cables, be sure you know what type of output and input connectors your various components require. Also determine the length of cable you'llneed.

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE THIS (POLARIZED) PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

Polarized Plug

Remote Control Battery Installation & Replacement

Battery Installation

Batteries: Use two "AA" batteries.

1.Turn the Transmitter face down. To remove bottom cover, press down on marking and slide cover off in the direction indicated.

2.Install the batteries as shown in the battery compartment. (Polarity (+) or (-) must be correct.)

3.Replace the cover and slide in reverse until the lock snaps.

Precaution on Battery Use

Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control Transmitter.

Observe the Following Precautions:

1.Batteries must be replaced as a pair.

2.Do not combine a used battery with a new one.

3.Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when Remote Control reacts sporadically or stops operating the Receiver.

IIII II

® ®

_J {u

4.,I 4,,I

4.1

® ®

Slide Cover Back

Press Down Here And

ooooooooo

ooooooo ooooo

ooo

J

-5-

Page 5
Image 5
Panasonic TQB2A0952 manual Installation, Receiver Location, Optional External Equipment Connections, AC Power Supply Cord