Panasonic TQBJ0299-3 manual Zoom, Clock Phase, Geometry

POSITION menu

Menu items displaying pattern depends on signals

Signals from RGB 1 IN/RGB 2 IN/DVI-D IN and SDI (PT-DZ6710 only)

DEFAULT H THROUGH H 16:9 H 4:3 H H-FIT H V-FIT H HV-FIT H DEFAULT

Signals from S-VIDEO IN

VID AUTO H S1 AUTO H VID AUTO(PRI.) H THROUGH H 16:9 H 4:3 H H-FIT H V-FIT H HV-FIT H VID AUTO

Signals from other terminals

VID AUTO H THROUGH H 16:9 H 4:3 H H-FIT H V-FIT H HV-FIT H VID AUTO

NOTE:

•If you project an image with an unmatched aspect ratio, the image may distort or some portions may be cropped. Select an aspect ratio which preserves the intention of the image creator.

•The order of ASPECT types is defined not only by the input method but also by the input signals.

•If you project a copyrighted image enlarged or distorted by using ASPECT function in commercial use in a public place, such as a restaurant or hotel, you might infringe on the copyright of the creator which is protected by copyright law.

•Selectable aspect ratio options vary according to input signals.

ZOOM

You can control the digital zoom scale vertically and horizontally, and digital zoom area. See “SCREEN SETTING” on page 25.

Zooming range: 50% to 999%

When ASPECT setting is DEFAULT

You can change the zoom area in the setting of SCREEN FORMAT in SCREEN SETTING.

	Zoom area is the factory default setting
INTERNAL	of SCREEN FORMAT in SCREEN
	SETTING.
FULL	Zoom area is the setting of SCREEN
	FORMAT in SCREEN SETTING.

Press I H to change the zoom scale of VERTICAL and

HORIZONTAL.

When ASPECT setting is THROUGH

Digital zoom is not available.

When ASPECT setting is others

Zoom area is the setting of SCREEN FORMAT in

SCREEN SETTING.

Press I H to change the zoom scale of VERTICAL and

HORIZONTAL.

CLOCK PHASE

If you have interference patterns of the projected image, which is sometimes referred to as moire or noise, you can fine adjust the timing of the clock. (Signals from RGB 1 IN/RGB 2 IN only)

NOTE:

•With PT-DW6300 and PT-D6000, if the projecting signal’s dot clock frequency is higher than 150 MHz, the adjustment may not make a difference.

GEOMETRY

(PT-DZ6710 only)

You can project on to specially shaped screens, such as distortional and cylindrical shaped screens, using unique image processing system. Press I H to cycle through the options.

OFF	Deactive
KEYSTONE	Adjusts projected image when
	distorted to a trapezoid.
CURVED	Adjusts projected image when
	distorted to a curved surface.
PC	For performing geometry correction
	from a connected computer.

NOTE:

•GEOMETRY adjustment should be carried out by a person who is familiar with the projector or by a service person because a high level of skill is required to make successful adjustment.

Settings

ENGLISH - 19