Panasonic TU-HDS20 manual Hdtv Digital Receiver connection to Conventional TV, Below

GETTING STARTED

Step 2b. HDTV Digital Receiver connection to Conventional TV

Follow this diagram when connecting the HDTV Digital Receiver to a conventional TV or Monitor. Terrestrial and digital signal can be received by connecting the digital receiver to the TV or Monitor.

SATELLITE RFOUT

CONVENTIONAL TV/MONITOR

AUDIO VIDEO		S -VIDEO
R	L	NOTE: S-VIDEO AND VIDEO
INPUT		CABLES NOT INCLUDED
		Connect the
		S-Video or
ANT IN		video cable.
		See Note
		below.

®

IN

ANT IN

CH3 CH4

R-AUDIO-L

HDTV DIGITAL RECEIVER
WARNING	!
RISK OF ELECTRIC SHOCK
DO NOT OPEN

MODELNO.

SERIAL NO.

AC 120V 60Hz

MAX AMPS MANUFACTURED

RGB/YPBPR

H-SYNC-L	R-AUDIO-L VIDEO S-VIDEO
DIGITAL OUTPUT	NTSC OUTPUT

		DISTRIBUTED BY
		MATSUSHITA ELECTRIC
		CORPORATION OF AMERICA
		ONE PANASONIC WAY,
DIGITAL		SECAUCUS, NEW JERSEY 07094
AUDIO OUT TEL LINE	ASSEMBLED IN MEXICO
(AC-3)

HDTV DIGITAL RECEIVER

TERRESTRIAL OR

CABLEANTENNA

CONVENTIONAL TV SETUP

Procedure

•Select 480i mode by using the Video Out button on the front panel.

•Connect the RF OUT to the ANT IN of the television or connect video cable from the video output jack on the HDTV Digital Receiver to the video input jack on the TV.

OR

•Connect S-VIDEO Cable from the NTSC S-VIDEO output jack on the HDTV Digital Receiver to the S-VIDEO input jack on the TV.

Note: Connect either the S-Video or video input/output as shown above.

•S-Video will provide better picture quality.

•If both S-Video and video are connected, S-Video will override video.

•Connect audio cables from the left and right NTSC audio output jacks on the HDTV Digital Receiver to the left and right audio input jacks on the TV.

Note: Modem should also be connected to a telephone jack using the supplied modem cable if impulse pay per view services are desired.

30