VIDEO page
Perform the settings of the VIDEO OUT connectors respectively. It is necessary to apply the same parameters (values) set on the VIDEO page of the encoder as the settings of the encoder for the settings on this menu.
Notes
•Click the [SET] button to save the changed settings. Otherwise, the changed settings will not be saved. When the settings are changed, restarting the decoder is necessary. The changed settings will be valid after restarting the decoder.
Restarting the decoder can be performed on the MAINTENANCE page.
Click the [MAINTENANCE] button in the left column to display the MAINTENANCE page, and click the [RESTART] button to restart the decoder.
•Do the following when changing the multicast transmission to the unicast transmission.
Stop the streaming of the encoder before changing the settings of the decoder. Select "UNICAST" on this page after clicking the [STOP] buttons for all channels on the CONTRL/STATE page of the encoder.
It is recommended to set the "RECEIVING STREAM IP ADDRESS" and "RECEIVING STREAM PORT No." as follows.
CH1: IP address of the decoder/60000
CH2: IP address of the decoder/60001
CH3: IP address of the decoder/60002
CH4: IP address of the decoder/60003 Confirm that the "RECIVING STREAM IP ADDRESS" and the "RECEIVING STREAMING
PORT No." for all the channels have the same IP addresses and the port number entered for the "DESTINATION IP ADDRESS" and "DESTINATION PORT No." on the VIDEO page of the encoder. After the confirmation, open the CONTROL/STATE page of the encoder and click the [START] buttons for all channels.
•Click the [START] button after changing the IP addresses for "RECEIVING STREAM IP ADDRESS" and port numbers for "RECEIVING STREAM PORT No." when changing the stream to be displayed on the monitor temporarily. Select how to receive the streaming video and audio from "UNICAST" or "MULTICAST".
The default setting is "MULTICAST" for all channels.
■Item Descriptions
CH1 - CH4
Numbers of the VIDEO OUT 1 - 4 connectors of the decoder
UNICAST/MULTICAST
Select how to receive the streaming video and audio from "UNICAST" or "MULTICAST".
The default setting is "MULTICAST" for all channels.
RECEIVING IP ADDRESS/RECEIVING PORT No.
The "DESTINATION IP ADDRESS" and the "DESTINATION PORT No." should be the same values entered for the "RECEIVING IP ADDRESS" and the "RECEIVING PORT No." of the decoder. If they are not the same, streams cannot be displayed on monitors connected to the decoder. 1024 to 65535 are available for the "DESTINATION IP ADDRESS".
The default settings of the "DESTINATION IP ADDRESS" and the "DETINATIONPORT No." for "CH1", "CH2", "CH3" and "CH4" are as follows.
CH1: 239.192.0.1/50000
CH2: 239.192.0.2/50000
CH3: 239.192.0.3/50000
CH4: 239.192.0.4/50000
When "UNICAST" is selected, refer to "Notes" in the left column on this page.
69