61
■Item Descriptions
CAMERA CONTROL
Click this link text to display the CAMERA CONTROL
page.
On the CAMERA CONTROL page, it is possible to
control the camera and to display the camera
settings menus.
FIRMWARE UPDATE
Update the firmware of the encoder by executing the
update files sent to the encoder in advance.
Refer to the next page for more information about the
firmware update.
RESTART
Click the [RESTART] button to restart the encoder. It
will take around 2 minutes and 45 seconds for the
encoder to become operable after the [RESTART]
button is clicked. During restart, it is impossible to
operate the encoder.

■EXCLUSIVE COMMAND AUTHENTICA-

TION SETUP

ACCEPT EXCLUSIVE COMMAND IP ADDRESS
Enter the IP address of the device allowed to access
the encoder and to enter the exclusive command.
If no IP address is entered, exclusive command will
be accepted by the encoder from any device (even
the host authentication setting will be ignored.)
DELETE IP ADDRESS
Select an IP address to be deleted from the pull-
down menu, and click the [DELETE] button.
Confirm that the IP address has been deleted from
the pull-down menu.
MAINTENANCE page
It is possible to confirm the angle of view of the camera
connected to the encoder, to perform the camera control
and to update the firmware of the encoder.
Note: The "EXCLUSIVE COMMAND" is the exclusive
command to control the encoder.
The exclusive command is sent via TCP/IP or
UDP/IP to the encoder and it makes possible to
control cameras faster.
Refer to your dealer for further information.