Panasonic WJ-GXD900, WJ-GXE900 manual User

USER page

Perform the settings to restrict users to access the encoder on this page.

It is possible to restrict access to the encoder by the "USER AUTHENTICATION" and the "HOST

AUTHENTICATION".

Refer to the next page when using both the "USER AUTHENTICATION" and the "HOST

AUTHENTICATION".

Notes

•The following user (administrator) is registered as default setting.

USER NAME: admin

PASSWORD: none (blank)

ACCESS LEVEL: 1 (ADMINISTRATOR)

•It is impossible to delete the user "admin".

It is possible to set a password for the user "admin". However, if the entered password is forgotten, it is necessary to reset all the settings to the default settings by setting the "SW2" switch on the front panel of the encoder to "ON".

When the password is entered, write it down and keep it safely so as not to forget it.

•Click the [SET] button to save the changed settings. Otherwise, the changed settings will not be saved.

■Item Descriptions

●USER AUTHENTICATION

Select "ON" or "OFF" to set whether to apply the user authentication or not.

However, when using a web browser to perform the settings, it is necessary to be authenticated regardless of the "ON" or "OFF" setting.

The default setting is "OFF".

●SETUP

Up to 16 users can be registered.

A registered user can be deleted using the "DELETE" pull-down menu in the section at the bottom of this page.

USER NAME/PASSWORD

Enter up to 16 alphanumeric characters for the user name and the password.

However, the colon (:) and the semicolon (;) cannot be used.

PASSWORD (TWICE)

Enter the password again for confirmation.

ACCESS LEVEL

Select one of the following for the access level.

1 (ADMINISTRATOR)

It is possible to perform the settings on the settings pages and operate the encoder using the CGI commands.

2 (CAMERA CONTROL)

It is possible only to operate the encoder using the CGI commands. It is not possible to perform the settings on the settings pages.

[ADD] button

Click to add a user after entering the user information.

●DELETE

Select a user to be deleted from the pull-down menu, and click the [DELETE] button.

In the pull-down menu, user names are displayed with their access level as follows.

Example: admin[1]

Confirm that the user has been deleted from the pull- down menu.

Note: To set the password for the default user "admin", enter "admin" in the "USER NAME" input box, and the password in the "PASSWORD" and "PASSWORD (TWICE)" input boxes.

The access level setting will be fixed to "1 (ADMINISTRATOR)".

59