Panasonic WX-CC412, WX-CC411 operating instructions Message Meaning Action, Reboot

Browser Operation

Important

ppCheck the [HTTP Status] / [HTTPS Status] after 10 minutes have passed since starting up the router and Center Module. pp The following chart shows the meaning and action to take for each port forwarding [HTTP Status] / [HTTPS Status].

Message	Meaning	Action
— (no message)	Connected without port forwarding.	To change the connection type, click the [Installation] button,
		then the [Network] tab and set the connection type.
Disabled	Internet publishing has not been set up	Click the [Installation] button, then the [Network] tab and set
	for a Center Module that is using the	“Auto port forwarding” to “ON” in “UPnP”.
	router UPnP function.
Enabled	Internet publishing has been set up	—
	properly for a Center Module that is
	using the router UPnP function.
Setting	Automatic port forwarding is being set	Wait for the router to finish setting up.
	up for a Center Module that is using the
	router UPnP function.
Deleting	After disabling automatic port	Wait for the system to finish deleting the router UPnP settings.
	forwarding for a Center Module that
	is using the router UPnP function, the
	UPnP settings of the router are being
	deleted.
Failed to set	The router is not UPnP compatible, or	pp The UPnP function of the router has been disabled.
	the UPnP function has not been set.	Refer to the instruction manual for the router to enable the
		UPnP function.
		pp The router does not have a UPnP function.
		Set port forwarding according to the instruction manual for the
		router.
		pp The power for the router has been turned off.
Failed to delete	After changing to a setting where
		Turn on the power for the router, then restart the Center
	Internet publishing is not set for a
		Module.
	Center Module that is using the router
		pp If the network status for the Center Module reads “Static”,
	UPnP function, the system failed to
		the network settings are incorrect.
	delete the UPnP settings of the router.
		Confirm the default gateway and subnet mask settings for the
		Center Module network.
		pp Some routers may not work with the Center Module, even
		if they are UPnP compatible and have been enabled,
		because they are not compatible with the Center Module. In
		such cases, set port forwarding according to the instruction
		manual for the router.

[Reboot]

Clicking the [Reboot] button restarts the Center Module.

Important

ppWhen the Center Module is rebooted from a browser, the Center Module will restart without displaying a warning on the LCD display. Be sure to check the operational status before rebooting from a browser.

29