3. Using the Web Interface
SNMP
Use the SNMP (Simple Network Management Protocol) screen to enable and configure the SNMP agent and SNMP trap managers.
The SNMP feature generates a trap whenever the IP address of the router changes (except through the Troubleshooting Management Link). The trap sent contains the following:
Community (“public”)
sysObjectID for the router
IP address of the agent sending the trap
Time stamp (sysUpTime)
Serial Number of the router
IP address of the router
Interface name
To configure SNMP:
Procedure
1.From the Home screen, click on Advanced and under Advanced, select SNMP. The SNMP screen appears.
2.Enable the SNMP traps, then enter up to five Destination IP Addresses and Community names.
The Apply button will temporarily save these settings. To make the change permanent, click on Tools and select System Commands. On the System Commands page, click on Save All.
Figure 3-19. SNMP
April 2005 |
|
