3. Using the Web Interface
Configuring the LAN
To configure LAN parameters, click on Setup on the Home screen. Under LAN
Setup, click on LAN Configuration. The LAN Configuration screen appears.
Enable/Disable DHCP
By default, your CPE has DHCP server (LAN side) disabled. If you already have a DHCP server running on your network, do not enable a second DHCP server.
To enable DHCP:
Procedure
1.From the Home screen, click on Setup.
2.Under LAN Setup, select LAN Configuration. The LAN Group 1 Configuration screen appears.
Figure 3-14. LAN Group 1 Configuration
3.The DHCP server is enabled when “Enable DHCP Server” is selected. If you enable it:
—Specify a Start IP address. The Start IP Address is where the DHCP server starts issuing IP addresses. This value must be greater than the router's IP address value. For example, if the router's IP address is
April 2005 |
|
