2. Hardware Installation and PC Setup
4.If Internet Protocol (TCP/IP) does not appear as an installed component, click on Install.
5.In the Select Network Component Type dialog box, select Protocol, and then click on Add.
6.Select Internet Protocol (TCP/IP) in the Network Protocols list, and then click on OK.
You may be prompted to install files from your Windows 2000 installation CD or other media. Follow the instructions to install the files.
7.If prompted, click on OK to restart your computer with the new settings.
8.After restarting your PC,
9.In Network and
10.In the Local Area Connection Properties dialog box, select Internet Protocol (TCP/IP), and then click on Properties.
11.In the Internet Protocol (TCP/IP) Properties dialog box, click in the radio button labeled “Use the following IP address” and type 192.168.1.x (where x is any number between 2 and 254) in the IP Address field. Type 255.255.255.0 in the Subnet Mask field.
12.Click on OK twice to confirm and save your changes, and then close the Control Panel.
Windows ME
To configure the IP address under Windows ME:
Procedure
1.In the Windows task bar, click on the Start button, point to Settings, and then click on Control Panel.
2.
3.In the Network and
The Network Properties dialog box is displayed with a list of currently installed network components. If the list includes Internet Protocol (TCP/IP), the protocol has already been enabled, in which case you can skip to Step 11.
4.If Internet Protocol (TCP/IP) does not appear as an installed component, click on Add.
5.In the Select Network Component Type dialog box, select Protocol, and then click on Add.
6.Select Microsoft in the Manufacturers box.
April 2005 |
|
