3. Using the Web Interface
7.Select the encapsulation type (LLC or VC). If you are not sure which to use, just use the default mode.
8.Select the quality of service (QOS). Leave the default value if your ISP did not provide this information. Depending on the QoS you select, you may also enter:
—PCR (Peak Cell Rate)
—SCR (Sustainable Cell Rate)
—MBS (Maximum Burst Size)
—CDVT (Cell Delay Variation Tolerance)
If your DSL line is connected and your DSL provider is supporting DHCP, you can click on the Renew button and the CPE will retrieve an IP Address, Subnet Mask, and Default Gateway address. At any time you can renew the DHCP address by clicking on the Renew button.
Figure 3-10. DHCP Connection Setup
To complete the connection you must now click the Apply button. The Apply button will temporarily save this connection. To make the change permanent, click on Tools (at the top of the page) and select System Commands. At the System Commands page, click on Save All.
April 2005 |
