3. Using the Web Interface
Access Control
Access control allows certain PCs to access the router after the firewall is enabled.
Access control is enabled on a WAN connection only if the firewall is enabled globally (see Firewall/NAT Services on page
To enable any of the Access Control features:
Procedure
1.From the Home screen, click on Advanced.
2.Under Advanced, select Access Control. The Access Control screen appears. All Access Control rules have precedence over rules that were added via the Port Forwarding page.
3.The Apply button will temporarily save these settings. To make the change permanent, click on Tools and select System Commands. On the System Commands page, click on Save All.
Figure 3-30. Access Control
Log Out
Click on Log Out to close the session.
April 2005 |
