Patton electronic 2294, 2292 instruction

Model 2292 & 2294 Series Getting Started Guide	1 • General information

SmartNode 2292 and 2294 Leased-Line Extenders

The SmartNode 2292 and 2294 models are compact Leased-Line Extenderss over IP that support two or four VoIP channels, depending on the number of ports (see ﬁgure 2).

Model 2292

Ports

, 1.25A	Reset	ETH 0/1		ETH 0/0

Model 2294

Ports

, 1.25A	Reset		ETH 0/1			ETH 0/0

,1.25A

Reset

ETH	0/1

ETH

0/0

Ports

Figure 2. Examples of SmartNode 2292 and 2294 Series rear panels

The following base models (each equipped with two 10/100Base-T Ethernet ports) are available:

•SmartNode 2292/EUI (2 VoIP leased line channels)

•SmartNode 2294/EUI (4 VoIP leased line channels)

The port combinations are indicated in the extension of the model code. T he following model code conven- tions apply:

•The last number in the model code stands for the number of voice ports.

•EUI stands for external universal input power supply (see ﬁgure 3)

For example, the model code 2294/EUI describes a SmartNode conﬁgured as follows:

•4 voice ports

•External power supply

Note For a complete listing of available models, refer to the SmartNode

VoIP page at http://www.patton.com/voip/.

SmartNode Series Leased-Line Extenders overview

16

Image 16

Patton electronic SmartNode 2292 and 2294 Leased-Line Extenders, Examples of SmartNode 2292 and 2294 Series rear panels

Contents

Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables Audience About this guideStructure Precautions Safety when working with electricity Preventing electrostatic discharge damage General observations Typographical conventions used in this document General conventionsPage Chapter contents General information SmartNode Series Leased-Line Extenders overview SmartNode extender SmartNode 2294 shown SmartNode 2292 and 2294 Leased-Line Extenders Examples of SmartNode 2292 and 2294 Series rear panels Reset button behavior Ports descriptions SmartNode 2292 and 2294 front panels Applications overview Typical application Leased-line extension Hardware installation Planning the installation Create a network diagram see section Network information on Installation checklist Task Veriﬁed by Date Power source Site logNetwork information IP related information Installing the SmartNode extender Connecting cablesLocation and mounting requirements Mounting the SmartNode extender Installing an interface cable on the extender’s voice ports RJ-11, male Pin Signal Installing the Ethernet cable TX+ Connecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Introduction Connect the SmartNode to the network Conﬁgure the IP address Power connection and default conﬁgurationConnect with the serial interface Login LEDs status and monitoring Status LEDs LED Contacting Patton for assistance Warranty coverage Out-of-warranty serviceContact information Returns for credit RMA numbers Return for credit policyShipping instructions Appendix a Compliance information Compliance SafetyCE Declaration of Conformity Appendix B Speciﬁcations Data Services Quality of ServiceVoice Signaling Capacity Temperature Voice ProcessingManagement System Appendix C Cabling Connecting a serial terminal Serial console Ethernet 10Base-T and 100Base-T Ethernet cross-over Analog FXS Ethernet straight-through Appendix D Port pin-outs Ethernet 10Base-T and 100Base-T port Console portVoice port Appendix E Installation checklist Installation checklist