Analog FXS, Ethernet straight-through | Patton electronic 2292

Model 2292 & 2294 Series Getting Started Guide

C • Cabling

,1.25A

Reset

ETH	0/1

ETH	0/0

Ports

Hub

		Straight-through cable
RJ-45, male		RJ-45, male
Tx+	1	1	Rx+
Tx-	2	2	Rx-
Rx+	3	3	Tx+
Rx-	6	6	Tx-

Figure 19. Ethernet straight-through

Analog FXS

Applicable to SmartNodes equipped with FXS ports. The FXS ports are connected to analog terminals (phones, fax machines, answering machines) via cables terminated with RJ-11 connectors (see section “Voice port” on page 51 for details on port pinouts).

,1.25A

Reset

ETH	0/1

ETH	0/0

Ports

RJ-11, male		RJ-11, male

Figure 20. Connecting an FXS device

Analog FXS

49

Image 49

Patton electronic 2292, 2294 manual Analog FXS, Ethernet straight-through

Contents

Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables Audience About this guideStructure Precautions Safety when working with electricity General observations Preventing electrostatic discharge damage General conventions Typographical conventions used in this documentPage General information Chapter contents SmartNode extender SmartNode 2294 shown SmartNode Series Leased-Line Extenders overview Examples of SmartNode 2292 and 2294 Series rear panels SmartNode 2292 and 2294 Leased-Line Extenders Ports descriptions Reset button behavior SmartNode 2292 and 2294 front panels Applications overview Leased-line extension Typical application Hardware installation Create a network diagram see section Network information on Planning the installation Task Veriﬁed by Date Installation checklist Site log Power sourceNetwork information IP related information Connecting cables Installing the SmartNode extenderLocation and mounting requirements Mounting the SmartNode extender RJ-11, male Installing an interface cable on the extender’s voice ports Pin Signal TX+ Installing the Ethernet cable Connecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Connect the SmartNode to the network Introduction Conﬁgure the IP address Power connection and default conﬁgurationConnect with the serial interface Login LEDs status and monitoring LED Status LEDs Contacting Patton for assistance Out-of-warranty service Warranty coverageContact information Returns for credit RMA numbers Return for credit policyShipping instructions Appendix a Compliance information Compliance SafetyCE Declaration of Conformity Appendix B Speciﬁcations Quality of Service Data ServicesVoice Signaling Capacity Voice Processing TemperatureManagement System Appendix C Cabling Serial console Connecting a serial terminal Ethernet cross-over Ethernet 10Base-T and 100Base-T Ethernet straight-through Analog FXS Appendix D Port pin-outs Ethernet 10Base-T and 100Base-T port Console portVoice port Appendix E Installation checklist Installation checklist