Model 3088A Series Getting Started Guide | 2 • Configuration |
|
|
The three sets of DIP switches are externally accessible from the underside of the Model 3088A (see figure 4).
ON |
|
|
|
|
|
| S4 |
|
|
|
|
|
|
| |
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
ON |
|
|
|
|
|
| S3 |
|
|
|
|
|
|
| |
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
ON |
|
|
|
|
|
| S1 | |
1 | 2 | 3 | 4 | 5 | 6 | 7 | ||
8 |
Model 3088A
Figure 4. Underside of Model 3088A showing location of DIP switches
The three sets of DIP switches on the underside of the Model 3088A are referred to as S1, S3 and S4. For basic configuration, use DIP switch S1. For testing the 3088A, use DIP switch S3. To configure the rate, use DIP switch S4. This figure shows the DIP switch orientation with respect to ON and OFF positions is consistent for all switches.
System reset mode
To enter system reset mode, turn the
|
|
|
| ON |
|
|
| ||
|
|
|
|
|
1 |
|
|
| ON |
|
|
| ||
2 |
|
|
|
|
|
|
|
| |
3 |
|
|
|
|
|
|
|
| |
4 |
|
|
|
|
|
|
|
| |
5 |
|
|
|
|
|
|
|
| |
6 |
|
|
|
|
|
|
|
| |
7 |
|
|
|
|
|
|
|
| |
8 |
|
|
|
|
|
|
|
| |
|
|
|
|
|
DIP switch settings | OFF |
| |
You can configure the 3088A by setting the DIP switches to the desired positions before you |
|
power up the OnSite. If the DIP switches are set to anything other than all OFF or all ON, the OnSite will operate in DIP switch configuration mode. Once the device is powered up and operating in DIP switch config- uration mode, you cannot change configuration by any method until you power it down again.
Introduction | 22 |