Patton electronic 4400 manual Installing the IpChannel Bank, Location and mounting requirements

SmartNode 4400 Series Getting Started Guide 3 • Hardware installation

Location and mounting requirements

The SmartNode 4400 is intended to be placed on a desktop or similar sturdy, flat surface that offers easy access to the cables or be installed in a standard 19-inch rack chassis. Allow sufficient space at the rear of the chassis for cable connections. Additionally, you should consider the need to access the unit for future upgrades

and maintenance.

This completes the planning phase for installation. The next section begins the installation procedures.

Installing the IpChannel Bank

Unpacking the Model SN4400 series IpChannel Bank

Inspect the shipping carton for external damage. Note any damage before removing the container contents. Report any equipment damage to the shipping carrier immediately for claim purposes. Save all packing mate- rial in case you need to return an item to the factory for servicing.

The IpChannel Bank comes with the following items:

•Model SN4400 Series IpChannel Bank Quick Start Guide

•Model SN4400 Series IpChannel Bank

•An RJ-45-to-RJ-45 cable for use with the console and Ethernet ports

•A DB-9-to-RJ-45 (EIA-561) adapter for connecting a PC’s serial port to the IpChannel Bank console port

•Rack mounting kit with rack ears and mounting hardware

•CD-ROM containing product literature, the Model SN4400 IpChannel Bank Getting Started Guide and the Smartware Software Configuration Guide

Note Power cables are shipped separately from the Model SN4400 Series

IpChannel Bank

Note Contact Patton Electronics for the proper RJ-21X cable for the

FSX ports

IpChannel Bank chassis installation

Do the following:

1.If you have not done so already, remove the IpChannel Bank from its shipping container.

2.If you are installing the IpChannel Bank in a 19-inch rack, go to step 4. Otherwise, place the IpChannel Bank at the desired location.

3.Go to section “Connecting cables” on page 28

4.Install the rack mounting ears onto the IpChannel Bank using the mounting hardware provided.

5.Place the IpChannel Bank at the desired position in the rack.

6.Secure the IpChannel Bank in position with the mounting screws.

7.Go to section “Connecting cables” on page 28

Installing the IpChannel Bank 27