SmartNode 4400 Series Getting Started Guide

4 • Getting started with the SmartNode 4400 Series

 

 

Introduction

This chapter leads you through the basic steps to set up a new SmartNode and to download a configuration. Setting up a new SmartNode consists of the following main steps:

Note If you have not already installed the SmartNode, refer to chapter 3, “Hardware installation” on page 23.

1.Configuring the desired IP address (see figure 14). Refer to section “2. Connecting the SmartNode to the network” on page 39 for details.

 

40V

10

0-2

Hz)

-60

P

(510 AM

 

Rese

t

 

Telco

Ports

 

Console

Console port

ETH

0/0

ETH

0/1

 

Model 16F-561

adapter and cable

Laptop PC

Figure 14. Connecting the SmartNode to your laptop PC

2.Connecting the SmartNode to the network (see figure 15). Refer to section “1. Configure IP address” on page 36 for details).

 

240V

 

- Hz)

100-60

(501

AMP

Ports

Telco

Console

Reset

 

0/0

 

ETH

 

0/1

 

ETH

LAN

WAN

(ETH 0/0)

PC or workstation

Network

interface

or Telnet

 

LAN (ETH 0/1)

Internet or

WAN (optional)

Figure 15. Connecting the SmartNode to the network

Introduction

35

Page 35
Image 35
Patton electronic 4400 manual Connecting the SmartNode to your laptop PC