Getting started with SmartNode 4400 Series | Patton electronic

Chapter 4 Getting started with the
SmartNode 4400 Series
Chapter contents
Introduction	35
1. Configure IP address	36
Factory-default IP settings	36
Connect to the RS-232 console port	37
Login	38
Changing the WAN IP address	38
2. Connecting the SmartNode to the network	39
3. Loading the configuration (optional)	39
Bootloader	40
Start Bootloader	40
Start-up with factory configuration	41
Load a new application image (SmartWare) via TFTP	41
Load a new application image (SmartWare) via the serial link	43
Additional information	43

34

Image 34

Patton electronic manual Getting started with SmartNode 4400 Series, Chapter contents

Contents

SmartNode Mailsupport@patton.com Summary Table of Contents Table of Contents Getting started with the SmartNode 4400 Series Port pin-outs List of Figures List of Tables Audience PrecautionsAbout this guide Structure About this guide Safety when working with electricity Sonnel. Opening the SmartNode case will void the warranty Preventing Electrostatic Discharge Damage General observations Typographical conventions used in this document General conventions Chapter contents General information SmartNode 4400 Series overview Model SN4432 IpChannel Bank SmartNode 4400 Series detailed description Power Solid Green Power is applied SmartNode 4400 Series front panel SmartNode 4400 Series rear panels Telco ports Console port Ethernet ports Reset button behavior Applications overview Introduction SmartNode 4400 Series applications Bulk analog line extensions Legacy MTU/MDU migration to VoIP based networks Hardware installation Planning the installation Installation checklist Site log Network information AC Power MainsConﬁguration tools Location and mounting requirements Installing the IpChannel BankIpChannel Bank chassis installation Unpacking the Model SN4400 series IpChannel Bank Connecting cables Connecting the FXS ports Model SN4400 Ethernet port Connecting power Grounding the Model SN4400-AC and DC units Installing the power cables-AC units Installing the power cables-DC units DC connector, -DC and +DC input view Getting started with SmartNode 4400 Series Connecting the SmartNode to your laptop PC Factory-default IP settings Conﬁgure IP address Connecting to the RS-232 Console port Connect to the RS-232 console port Login Changing the WAN IP address Connecting the SmartNode to the network Loading the conﬁguration optional Bootloader Start Bootloader Start-up with factory conﬁguration Load a new application image SmartWare via Tftp Copy tftp//tftpserveraddress/server path/b1 flash Additional information Load a new application image SmartWare via the serial link Contacting Patton for assistance Warranty coverage Contact information Out-of-warranty service RMA numbers Appendix a Compliance information CE Declaration of Conformity Safety complianceCompliance Authorized European Representative Appendix B Speciﬁcations Ethernet interface Voice processing signaling dependentVoice connectivity FXS Console port Voice signaling Fax and modem support Management IP servicesVoice routing-session router Operating environment Power supply DimensionsWeight and power dissipation System Identiﬁcation of the SmartNode devices via Snmp SmartNode Model SysObjectID Appendix C Port pin-outs Ethernet 10Base-T and 100Base-T port EIA-561 RJ-45 8-pin port Blue Purple Blue Band marked color-codes for the 50-pin RJ-21X connector Violet Appendix D Factory Conﬁguration Factory Configuration Appendix E End user license agreement End User License Agreement Termination Other licenses Appendix F Installation checklist Task Veriﬁed by Date Appendix G Accessories Description Part Number