Peavey X-Eight HS, X-Eight RT owner manual See-solo clear

master RT module 6

solo control features

headphone level

This control governs the level at the headphone jack located in the front of the console under the arm rest.

solo clear

When this switch is lit, it indicates that at least one SOLO on the console is active.Depressing this switch will clear any active solos and this switch light will go out.

post-fader

This switch determines whether the SOLO system sources will be pre- or post-fader). It affects all inputs and outputs globally throughout the con- sole.

The audio from active solos is derived after the corresponding fader or MASTER level control.This is also referred to as AFL—after fader listen.

The audio from active solos is derived before the corresponding fader or MASTER level control.This is also referred to as PFL—pre-fader listen.

last pressed

The SOLO system can operate in two different modes, as described below. In either mode, a solo can be activated by pressing the desired local SOLO button.The button will light up to indicate that the solo is active,and press- ing an active SOLO button (the one that is lit) will make it inactive and the button's light will go out.

Any number of solos can be active at once.

There are two-ways to make active solos inactive.

1Press an active SOLO button (the one that is lit) and it will be made inactive.

2Press the SOLO CLEAR button

see—solo clear

Only one solo can be active at a time.

Pressing on any inactive SOLO button will activate that solo and remove any previous solo from the SOLO bus.

p. 119