EXPORT THE CONFIGURATION FILES AND TRANSFER THE DATA TO THE CM9700MDD-EVS
Once you have configured the CM9700MDD-EVS settings in the CM9700-MGR software, complete the following tasks to transfer the data to the matrix system components:
•Export the configuration files, and then transfer these files to the CM9700-CC1. These configuration files are named <NodeName>.* (each type of configuration file is named with a different extension).
•During the export process, an XML file is created for the CM9700MDD-EVS units on the node (refer to Figure 43); transfer this file, named MDD_<NodeName>.xml, to the CM9700MDD-EVS. In a multi-node matrix system, one XML file is created for each node.
Complete the following steps to transfer CM9700MDD-EVS configuration settings to the matrix system:
1.Use the CM9700-MGR Export option (click File > Export To Configuration Files) to export the configuration files. Refer to the Creating Configuration Files (Export) for the CC1 section in the CM9700-MGR Software Guide for instructions.
Configuration files can be exported either to a hard drive (either local or network) or to a floppy drive. If you specify a floppy drive for the export location, the CM9700-MGR will provide prompts during the export process to insert a floppy disk for the configuration files and a floppy disk for the XML file.
Figure 42. Exporting CM9700-MGR Configuration Files
Figure 43. CM9700MDD-EVS XML File
2.When the Export process is complete, complete the following tasks:
•Transfer the configuration files to the CM9700-CC1, as described in the Copying the Configuration Files to the CC1 section in the CM9700-MGR Software Guide.
•Transfer the XML file to the CM9700MDD-EVS through the Endura system, as described in step 3.
