AZ/EL LINE
MAIN MENU |
|
| Other Menu |
|
|
|
| Az/El/Direction | |
<Camera> |
|
| Proportional pan | On |
|
|
| Set Azimuth Zero | |
<Line Sync> |
|
| Park time minutes | 0 |
|
|
| Az/El | |
<Power Up> |
|
| Scan Speed deg/s | 25 |
|
|
|
| |
|
|
|
|
| Az/El Line | ||||
<Wiper> |
|
| Pattern Length | 1.5 min |
|
|
| Direction | |
<Limit Stop> |
|
| Spd Profile |
|
|
|
| Direction Line | |
<Alert> |
|
| <Zone Blank> |
|
|
|
| Zoom | |
<Other> |
|
|
| <Az/El/Direction> |
|
|
|
| Zoom Line |
ACK Alert |
|
| Exit |
|
|
|
| Disp Duration | |
Exit |
|
|
|
|
|
|
| Exit |
Az/El Line controls the vertical display position of the Azimuth/Elevation label. The label may be displayed on lines 3 through 10. Line 3 is the third line from the top of the screen and line 10 is located at the bottom of the screen. Line 10 is the default setting.
NOTE: Az/El display is not available while you are programming or running a pattern.
To program the vertical label position for Az/El:
1.Program preset 95 (28). The main menu appears.
2.Position the cursor (>) beside Other.
3.Press the Iris Open button to enter the Other menu.
4.Position the cursor (>) beside Az/El/Direction.
5.Press the Iris Open button to enter the Az/El/Direction menu.
6.Position the cursor (>) beside Az/El Line.
7.Press the Iris Open button. The cursor moves to the right.
8.Move the joystick up or down to view the available selections.
9.SELECT: Press the Iris Open button to make a selection.
CANCEL: Press the Iris Close button to cancel a selection.
31 |