Pelco ES31PC, ES30PC manual Limit Stops, Presets

LIMIT STOPS

MAIN MENU	Limit Stop Menu
<Camera>
	Limit Stops	Off
<Line Sync>	Set Man Limits
<Power Up>	Clear Man Limits
<Wiper>	Set Scan Limits
<Limit Stop>	Clear Scan Limits
<Alert>	Exit
<Other>
ACK Alert
Exit

NOTE: Limit stops are inactive while setting items in the program menu (e.g. azimuth zero, scan limits, manual pan limits).

TURNING LIMIT STOPS ON OR OFF

To change the limit stop mode:

1.Program preset 95 (28). The main menu appears.

2.Position the cursor (>) beside Limit Stop.

3.Press the Iris Open button to enter the Limit Stop menu.

4.Position the cursor (>) beside Limit Stops.

5.Press the Iris Open button. The cursor moves to the right, beside the word On or Off.

6.Move the joystick up or down to toggle between On and Off.

7.SELECT: Press the Iris Open button on your keyboard to select your choice.

CANCEL: Press the Iris Close button if you do not want to change the setting.

PROGRAMMING LIMIT STOPS

Manual Limit Stops

When manual limit stops are set, a (joystick/pan and tilt keys) pan operation stops when a limit stop is reached. The manual limit stops can be set in one of two ways:

•At the controller by programming presets 90 (23) and 91 (24).

•At the controller by programming the Limit Stops menu.

Presets

Refer to the documentation for your control system for programming presets, and then do the following:

1.Make sure limit stops are turned ON, then exit the menu.

2.Push the joystick left until you reach the limit you want the camera to go to on the left.

3.Program preset 90 (23).

4.Push the joystick right to the limit you want the camera to go to on the right.

5.Program preset 91 (24).

Setting presets 90 (23) and 91 (24) to the same point disables manual limit stops.

NOTE: Programming preset 90 (23) disables the manual limit stops until preset 91 (24) is set. Preset 90 (23) is the left manual limit and preset 91 (24) is the right manual limit.

C311M-N (6/06) 39