132
Serial Port Profiles
Session Strings Controls the sending of ASCII strings to serial devices at session start and
session termination as follows;
zSend at Start - If configured, this string will be sent to the serial device on
power-up of the IOLAN, or when a kill line command is issued on this
serial port. If the "monitor DSR" or "monitor DCD" options are set, the
string will also be sent when the monitored signal is raised.
Range: 0-127 alpha-numeric characters. Non printable ascii characters
must be entered in this format <027>. The decimal numbers within the
brackets must be 3 digits long (example 003 not 3).
zSend at End - If configured, this string will be sent to the serial device
when the TCP session on the LAN is terminated. If multihost is
configured, this string will only be send in listen mode to the serial device
when all multihost connections are terminated.
Range: 0-127 alpha-numeric characters. Non printable ascii characters
must be entered in this format <027>. The decimal numbers within the
brackets must be 3 digits long (example 003 not 3).
zDelay after Send—If configured, a delay time is sent to the device. This
delay can be used to provide the serial device with time to process the
string before the session is initiated.
Range: 0-65535 ms
Default: 10 ms
Dial In If the console port is remote and will be dialing in via modem or ISDN TA,
enable this parameter.
Default: Disabled
Dial Out If you want the modem to dial a number when the serial port is started, enable
this parameter.
Default: Disabled
Dial Timeout The number of seconds the IOLAN will wait to establish a connection to a
remote modem.
Range: 1-99
Default: 45 seconds
Dial Retry The number of times the IOLAN will attempt to re-establish a connection with
a remote modem.
Range: 0-99
Default: 2
Modem The name of the predefined modem that is used on this line.
Phone The phone number to use when Dial Out is enabled.