RADIUS and TACACS+ 390
TACACS+
Accessing the IOLAN from the Network User Example Settings

The following example shows the parameters that can be set for users who are accessing the IOLAN

from the Ethernet side. These settings should be included in the TACACS+ user configuration file.

# Settings for telnet/SSH access
service = raccess
{
priv-lvl = x # x = 12-15 (Admin)
# x = 8-11 (Normal)
# x = 4-7 (Restricted)
# x = 0-3 (Menu)
Perle_Line_Access_i=x # i = port number
# x = 0 (Disabled)
# x = 1 (Read/Write)
# x = 2 (Read Input)
# x = 3 (Read Input/Write)
# x = 4 (Read Output)
# x = 5 (Read Output/Write)
# x = 6 (Read Output/Input)
# x = 7 (Read Output/Write)
timeout=x # x = session timeout in seconds
idletime=x # x = Idle timeout in seconds
Perle_Clustered_Port_Access=x # x = 0 (Disabled)
# x = 1 (Enabled)
}
# Settings for WebManager and DeviceManager access
service=EXEC
{
priv-lvl = 12 # x = 12-15 (Admin)
Perle_Line_Access_i=x # i = port number
# x = 0 (Disabled)
# x = 1 (Read/Write)
# x = 2 (Read Input)
# x = 3 (Read Input/Write)
# x = 4 (Read Output)
# x = 5 (Read Output/Write)
# x = 6 (Read Output/Input)
# x = 7 (Read Output/Write)
Perle_Clustered_Port_Access = 1 # enable clustered port access
}
Note: Users who are accessing the IOLAN through WebManager or DeviceManager and are being

authenticated by TACACS+ must have the Admin privilege level and the TACACS+ service

level must be set to EXEC.