171
Serial Port Profiles
Advanced Tab Field Descriptions
Configure the following parameters:
Break Length When the IOLAN receives a command from its peer to issue a break signal,
this paramters defines the length of time the break condition will be asserted on
the serial port
Default: 1000ms (1 second)
Delay After Break This parameter defines the delay between the termination of a a break
condition and the time data will be sent out the serial port.
Default: 0ms (no delay).
Session Strings Controls the sending of ASCII strings to serial devices at session start and
session termination as follows;
zSend at Start—If configured, this string will be sent to the serial device
on power-up of the IOLAN or when a kill line command is issued on this
serial port. If the "monitor DSR" or "monitor DCD" options are set, the
string will also be sent when the monitored signal is raised.
Range: 0-127 alpha-numeric characters
Range: hexadecimal 0-FF
zSend at End—If configured, this string will be sent to the serial device
when the TCP session on the LAN is terminated. If multihost is
configured, this string will only be send in listen mode to the serial device
when all multihost connections are terminated.
zRange: 0-127 alpha-numeric characters
Range: hexadecimal 0-FF
zDelay after Send—If configured, will inset a delay after the string is sent
to the device. This delay can be used to provide the serial device with time
to process the string before the session is initiated or terminated.
Default: 10 ms