150
Serial Port Profiles
Advanced Tab Field Descriptions
Configure the following parameters:
Port The UDP port to use.
Default: 0 (zero)
Session Strings Controls the sending of ASCII strings to serial devices at session start as
follows;
zSend at Start—If configured, this string will be sent to the serial device
on power-up of the IOLAN or when a kill line command is issued on this
serial port. If the "monitor DSR" or "monitor DCD" options are set, the
string will also be sent when the monitored signal is raised.
Range: 0-127 alpha-numeric characters
Range: hex 0-FF
zDelay after Send—If configured, will inset a delay after the string is sent
to the device. This delay can be used to provide the serial device with time
to process the string before the session is initiated or terminated.
Default: 10 ms