Philips DTR1000 Quick start up / First installation / Channel scan, You already have an aerial

English

6Quick start up / First installation / Channel scan

6.1 Quick start

•You already have an aerial

•Your aerial is correctly pointed at the terrestrial transmitter corresponding to your area.(1)

•Your digital receiver connection is according to the diagram depicted in chapter 5.1 or 5.2.

•Your digital receiver is ON and the WELCOME screen (shown here) pops up.

•The selection is on "Language". Press the * button to open the selection window (right part of the screen). Use the 8 or 9 button to select the wanted language (1) and press the + button to store your choice. The selection is back on "Language".

•Press the 9 button , the selection is on "Country", Press the * button to open the selection window . Use the 8 or 9 button to select the wanted country and press the + button to store your choice. The selection is back on "Country".

•Press the 9 button , the selection is on "Install" and press the * button to start scanning for channels.

•The receiver scans the RF band(s) and reports scanning progress and found channels.

•When scanning is completed:

- Either scanning ended successfully, found channels are displayed and the digital receiver tunes the first channel in the list. If so proceed to chapter 7.

- Or scanning failed and stopped while the "Check signal" screen pops up. If so proceed with chapter 6.2.

Note:

(1) If your country is not shown in the list select the "Other" country option.

If you want to set another country while the first installation has already been performed successfully you shall first restore the receiver virgin mode (see chapter 10.1) then the first installation will automatically be re-launched (see chapter 6.1).

12Q U I C K S TA R T