Philips DTR1000/00M manual Advanced settings, Restore virgin mode, Change remote control setting

10 Advanced settings

10.1 Restore virgin mode

"Install wizard" is shown only once at the first power up of your receiver.

If you want to reinitialise your receiver and put it back to virgin / factory mode, follow the steps below.

•Disconnect your receiver from the mains.

•Keep pressing the Front Panel '+' button while re-connecting your receiver to the mains.

•The left hand LED will start to blink orange while right hand LED is off.

•Release the Front Panel '+' button.

•Briefly press the front Panel '+' button.

•Right hand LED turns on RED and the left hand LED is blinking Red.

•Enter the following code with the remote control: '9' '9' '0' '0'.

•Once entered, the left hand LED turns shortly Green. In case of a bad code entered, the left hand LED stays Red.

•Wait until the receiver re-starts by displaying the First Install Wizard.

Note: After this procedure, your PIN code has also been reset to its factory setting ('0', '0', '0', '0'), and all "Favourite" lists will be lost.

Note: At first power up of the remote control (or battery change while pressing a button) the default factory setting (value 3) is restored.

Change Receiver Remote Control Configuration:

-After you changed the remote control setting to the desired value:

-Disconnect your receiver from the mains.

-Keep on pressing the Front Panel '+' button while re-connecting your receiver to the mains…

-…up to the time the Multicoloured LED is blinking orange while Red LED remains on all the time.

-Then release the '+' button.

-Press the OK key on your remote control.

-The Multicoloured LED becomes Green if the new code is accepted.

-The Multicoloured LED becomes Red if the received code is not accepted. The receiver will then use the default factory setting of the remote control.

English

10.2Change remote control setting

If you have other equipment in your home and the remote control of the Philips receiver interferes with them, you can change the setting of the remote control. Change Remote Control Configuration:

-Press number buttons 1 and 3 simultaneously for 3 seconds.

-Release the two buttons simultaneously.

-Enter the new setting within 60 seconds:

-By pressing number button 4 (corresponding to new setting).

-Or by pressing number button 3 to come back on the default factory setting.

10.3You forgot your PIN code / Master PIN code

If you have forgotten your PIN code, you have the possibility to reset it to the default PIN Code ('0', '0', '0', '0').

To reset the PIN Code, you have to enter the Master PIN Code in any Pin Code request menu. This will have the effect to accept the PIN Code and to reset the PIN Code to the default PIN Code of the receiver.

The Master PIN Code is the following: ('RED', '3', '8', '9', '5').

Note: Keep this code secret to prevent your children from using it.

A DVA N C E D S E T T I N G S 31