Philips DTR1000/00M manual Unpacking / Putting the receiver in your existing set up

2Unpacking / Putting the receiver in your existing set up

English

2.1 Unpacking

Start by unpacking your receiver. You will find the following cables and accessories:

-The digital terrestrial receiver

-The remote control and batteries (2 x LR6 AA 1,5 V)

-One SCART lead

-One RF coaxial lead

-A mains cord

-A user manual

-A Guarantee card

-A stand for using the receiver in the upright position

Note: As advised in chapter 5 make use of the Scart lead provided. It has been selected to get the best picture quality and performance out of your digital receiver .

Plastic bags can be dangerous. To avoid suffocation keep the bag away from babies and children.

The Symbol on the packaging means that material is recyclable.

If the receiver will not be used for a long time, unplug the mains cord from the wall socket.

2.2Putting the receiver in your existing set up

-Your receiver can be integrated in different ways within your existing Audio- Video set up. The receiver can be used in the horizontal or vertical position. If you decide to use your receiver in the upright position, follow the instructions below. Unpack the stand, place it on a horizontal surface with click fit side on the right and lug side on the left.

-Take the receiver as shown below (rear panel on the left side / coaxial connectors on the bottom side).

-Insert the stand lug in the slot located on the front of the receiver, close to the Philips badge.

-Rock the receiver to insert the stand lug fully in the slot until it is locked by the click fit.

-From now on, your receiver can be used in the upright position.

Note: Removing the stand can be done by first unlocking the click fit at the rear side of the stand, rocking and pulling back the receiver to extract it from the stand lug.

4UNPACKING