Philips DTR1000/00M manual Scanning has failed again, Quick Start

6.2Scanning has failed / check installation / check signal from aerial

Scanning failed therefore before making a new scanning check:

-Aerial cable.

-Check the aerial connection to your digital receiver. Refer to the connection diagram of chapter 5.1 or 5.2

-Check channel(s) available in the region corresponding to your area.

-Check signal quality, by means of the "Check signal" menu beside.

•Press the 9 button to select the "RF channel" option.

•Press the * button and scroll with the 9 or 8 button to select the wanted RF channel number, corresponding to your area.

•Check signal strength and quality on bar meters.

•Either signal is good enough (orange or green bar meters) then choose the "Install" option and select the "Re-start" option to scan channels one more time. When scanning ends successfully, channels found are displayed and the digital receiver tunes the first channel in the list. . If so proceed to chapter 7.

•Or signal is bad or no signal is available (red bar meter or no bar at all). Then refer to chapter 6.3.

6.3 Scanning has failed again

You could not scan the channels and this was repeated after checking the signal quality delivered by your aerial. Either your aerial is not pointing properly at the digital TV transmitter, or your aerial installation needs to be upgraded or you are not in the coverage area to correctly receive digital Television.

For a proper diagnosis, call your electrical retailer.

English

QUICK START 13