15
English
3139 246 14221
Option 4 : Using Antennajacks only
Use this connection only if your TV set
has a single Antenna In jack and does
not have any audio/video jacks. For this
type of connection, you need to set the
channel of the TV set to follow that of
the DVD recorder.
Have the following cable ready:
1) Antenna cable
1Turn off your TV and remove the
antenna cable from your TV (or Satellite
Receiver/Cable Box.) Insert it to the
ANTENNA input jack at the back of
the DVD recorder.
2Use the supplied antenna cable to
connect the DVD recorder’s TV output
jack to the antenna input jack at the back
of your TV set.
3Connect the power cable from the DVD
recorder’s ~ MAINS to the power
supply.
TV
123
4Press STANDBY-ON 2 on the DVD
recorder to turn it on.
➜The message 'IS THE TV ON?'
appears on the display panel.
5Turn on the TV power. Select the correct
Video In channel at the TV (see page 10.)
➜To switch between channel 3 and 4,
hold down button {3} or {4} on the
remote control to select the respective
channel.
➜The first installation menu
{ Language and Country } will appear
on the TV.
6Proceed to page 24 to continue the first
installation.
Helpful Hints:
– If the {LANGUAGE AND COUNTRY}
menu does not appear, check the cable
connections.
– To toggle between channel 3 and channel
4, you can press § button at the DVD
recorder front panel while plug in the main
cord of the DVD recorder to the power
supply.
Connecting to TV (cont’d)
Antenna or
Satellite/Cable TV signal
DVDR610_615_37_Engfinal434 8/16/04, 4:04 PM15