Troubleshooting
Problem
COPY PROT is displayedInsert recordable disc indication
Disc locked is indicated brieflyDoes not recordRecording is black and white onlyTimer recording does not workWrong TV channel was recorded after you programmed a recording using ShowView® system
Switch off; timer recording flashes on the TV screen
Memory full indication after pressingTIMER
Data error indication
Collision indication
Solution
–The video source (DVD, video tape, …) from which you want to record, is copy protected. Recording is not possible.
–Make sure a recordable DVD+R or DVD+RW disc is inserted.
–A write protected disc has been inserted. Cancel the write protection (see “Activating or deactivating the write protection”) or load a disc that is not write protected.
–The desired TV channel for recording is not stored or a wrong programme number (channel number) has been selected. Check the TV channels stored.
–The inserted disc is write protected. Remove the write protection or load another non write protected disc.
–An already finalised DVD+R disc has been inserted. Replace it by an unfinalised DVD+R disc.
–The equipment from which you are recording is connected to
–Make sure to switch the DVD recorder system to standby before the timer recording starts.
–Make sure the time/date is programmed correctly.
–Make sure all information in the timer entry is programmed correctly.
–The inserted disc is write protected. Remove the write protection or load another non write protected disc.
–Make sure no finalised DVD+R disc has been inserted.
–Make sure the time for VPS/PDC has been entered exactly to the minute.
–Check the aerial connection.
–1 Enter the ShowView® programming number of the desired TV channel.
2 Press OK to confirm.
3 Check the programme number entered in the line Prog.. If it does not correspond to the desired TV channel, select the input field and change the programme number.
4 Press OK to confirm.
–The DVD recorder system is switched on a few minutes before a timer
recording starts. However, a timer recording only works if the DVD recorder system is switched off. Press 2 to switch the DVD recorder system off.
–You already have programmed the maximum number of timer entries. No further recordings can be programmed unless an you clear one of the timer entries.
–The data for the recording could not be transferred. Check the date, start time and end time of the timer recording.
–The data for 2 timer recordings overlap. Change the data for one recording or delete one of the timer recordings. If you ignore the indication, the timer recording with the earlier start time will be recorded first.
The start of the second recording will be missing.
English
59