4 Get started
Caution
•Use the controls only as stated in this user manual.
Note
•Before pressing any function button on the remote control, first select the correct source with the remote control instead of the main unit.
•If you are not going to use the remote control for a long time, remove the battery.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number of your DVD Micro Theater.The model number and serial number are on the rear of your DVD Micro Theater.
Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
•Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.
For
1 Remove the protective tab to activate the remote control battery.
To replace the remote control battery:
1 Open the battery compartment.
2 Insert 1 CR2025 battery with correct polarity
3 Close the battery compartment.
Auto install radio stations
When you connect the DVD Micro Theater to the power supply for the first time, or no radio station is stored in this DVD Micro Theater, Plug and Play is activated to store all available radio stations automatically.
1 Connect the DVD Micro Theater to the power supply.
2 Press 
on the main unit to start installation.
»[AUTO] (auto) is displayed.
»The DVD Micro Theater automatically store radio stations with sufficient signal strength.
»When all the available radio stations are stored, the first preset radio station is broadcast automatically.
14EN
