Hookups With a Cable Box/DSS Receiver (cont’d) 9
This connection allows you to program an unattended recording of more than one unscram- bled channel and to watch one channel while recording another. After you connect the VCR, Cable Box/DSS Receiver, and TV as shown below, the features on this page will be available.
1.Connect a Cable signal to the VCR’s
ANT(enna) IN Jack.
CABLE 
BOX IN OUT ANT.IN
R 
AUDIO
L
RF OUT
VIDEO
CH3 CH4
2. Use an RF coaxial 
cable (supplied) to con- 
nect the RF OUT Jack
on the VCR to the IN Jack on the Cable Box/DSS Receiver.
3.Use a second RF coaxial cable to con- nect the OUT Jack on the Cable Box/DSS Receiver to the TV’s ANTENNA IN Jack.
75V |
|
ANT | / |
CABLE | |
IN
OUT
ANTENNA IN Jack
(on back of TV)
Recording One Channel/Watching Another
1
With the VCR in VCR position (the VCR light will appear on the display panel), use the CHANNEL Up/Down buttons at the VCR to select the channel you want to record. Start the recording.
2
Press the VCR/TV button once to put the VCR in TV position. (The VCR light will disappear.)
3
Use the CHANNEL Up/Down buttons on the TV to set the TV to the Cable Box/DSS Receiver output channel (03 or 04).
4
Use the CHANNEL Up/Down buttons on the Cable Box/DSS Receiver to select the channel you want to watch.
Playing a Tape
1
Press the VCR/TV button to put the VCR in VCR position (the VCR light will appear on the display panel).
2
Make sure the Cable Box/DSS Receiver is on the same channel as the VCR’s CH3/CH4 switch.
3
Use the CHANNEL Up/Down buttons at the TV to set the TV to the Cable Box output channel (03 or 04).
4
Press the PLAY button to play the tape.
Helpful Hints
•You cannot record scrambled chan- nels with this connection.
•This connection may not work with your cable system. You may have to use the connection shown on page eight.
