Pioneer AVH-P6850DVD Mixing AVG-VDP1 beep and audio sound, Correcting distorted sound, High-Low

Black plate (96,1)

Section

20 Initial Setup

!Sound from this system returns to normal when the muting or attenuation is can- celed.

%Touch TEL/GUIDE on the initial menu to select any of the muting, attenuation or off.

Touch TEL/GUIDE until the desired setting ap- pears in the display.

!MUTE – Muting

!ATT -20dB – Attenuation (ATT -20dB has a stronger effect than ATT -10dB)

!ATT -10dB – Attenuation

!OFF – Turn the sound muting/attenuation off

Notes

!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjustment is possible.

!Operation returns to normal when the phone connection or the voice guidance is ended.

Mixing AVG-VDP1 beep and audio sound

When connecting the AVG-VDP1 to this unit, a beep sound is occasionally outputted from the AVG-VDP1. To ensure the quality audio sound from this unit, set this function to GUIDE to properly mix the beep sound and the audio sound.

!You can operate this function only when a Pioneer Vehicle Dynamics Processor (AVG- VDP1) is connected to this unit.

!When the multi-channel processor (e.g., DEQ-P7650/DEQ-P6600) is connected to this unit, you cannot use this function.

!We recommend that you select GUIDE to ensure quality sound.

96 En

%Touch VDP MIX on the initial menu to switch the mixing of AVG-VDP1 beep. Touching VDP MIX switches the mixing set- tings between ALL (mixing all the time) and

GUIDE (mixing when a beep sound is out- putted).

Correcting distorted sound

You can minimize distortion that may be caused by the equalizer curve settings. Setting an equalizer level high can cause dis- tortion. If high sound is crippled or distorted, try switching to LOW. Normally, leave the set- ting at HIGH to ensure quality sound.

!Only when the multi-channel processor (e.g., DEQ-P7650/DEQ-P6600) is connected to this unit, you can operate this function.

%Touch D. ATT on the initial menu to switch the digital attenuator setting. Touching D. ATT switches the digital attenua-

tor settings in the following order:

HIGH—LOW

Setting the TV signal

When this unit is connected to a TV tuner, you need to adjust the TV signal suitable to your country TV signal setting.

!This function is initially set to AUTO so that this unit automatically adjusts the TV signal setting.

%Touch TV SIG on the initial menu to se- lect an appropriate TV signal.

Touching TV SIG switches TV signal settings in the following order: AUTO—PAL—NTSC—PAL-M—SECAM

<CRB2163-B>96