Pioneer DEH-600BT Disconnecting a cellular phone, Pairing a connected cellular phone

Section

02Operating this unit

After connected, this unit automatically changes to PH. BOOK DL (phone book down- load confirmation) display.

#If the connection fails, ERROR is displayed. In this case, check the cellular phone and try again.

4Use MULTI-CONTROL to decide to download the phone book from your cellu- lar phone or not.

Push MULTI-CONTROL left or right to select NO (No) or YES (Yes).

Press MULTI-CONTROL to decide.

When you select YES, this unit changes to

PH BOOK DOWNLOAD and the download op- eration automatically begins. After complet-

ing, DATA DOWNLOADED is displayed.

# When you select NO, the display reverts to normal.

3Push MULTI-CONTROL up or down to select a pairing assignment.

1(user phone 1)—2 (user phone 2)—3 (user

phone 3)

# Push MULTI-CONTROL left or right to switch

the BD address and device name.

# If a phone is already assigned to the user phone number, the new phone will overwrite the

old one.

# As you select each assignment, you can see whether or not a phone is already paired. If the assignment is empty, NO DATA is displayed.

4Press MULTI-CONTROL to pair the cur- rently connected phone.

When pairing is completed, COMPLETED is

displayed.

# If the pairing fails, REGISTER ERROR is dis- played. In this case, return to step 1 and try

Disconnecting a cellular phone

1 Display the connection menu.

Refer to Introduction of connection and regis- tration on page 23.

2Use MULTI-CONTROL to select

DISCONNECT PHONE.

3Press MULTI-CONTROL to disconnect a cellular phone from this unit.

After disconnection is completed, DISCONNECTED is displayed.

Pairing a connected cellular phone

Pairing is usually performed automatically dur- ing the connection operation. You only need to perform this operation manually when your phone is connected temporarily for any reason. We recommend you pair the phone to this unit to make best use of the technology.

1 Display the connection menu.

Refer to Introduction of connection and regis- tration on page 23.

2Use MULTI-CONTROL to select

SET PHONE.

again.

Deleting a registered phone

1 Display the connection menu.

Refer to Introduction of connection and regis- tration on page 23.

2Use MULTI-CONTROL to select

DELETE PHONE.

3Push MULTI-CONTROL up or down to select a pairing assignment.

1(user phone 1)—2 (user phone 2)—3 (user

phone 3)

# Push MULTI-CONTROL left to display the BD

address of the selected device.

# If the assignment is empty, NO DATA is dis- played and operation is not possible.

4Push MULTI-CONTROL right to select

DELETE YES.

DELETE YES is displayed. Deleting phone is now on standby.

5Press MULTI-CONTROL to delete the phone.

After the phone is deleted, DELETED is dis- played.

26 En