Pioneer DEH-600BT Connecting and disconnecting a cellular phone, 02Operating this unit

Section

02Operating this unit

!BT HANDS FREE (new phone)

!DELETE PHONE (delete phone)

If the phone is connected but not paired The following functions can be operated.

!SET PHONE (phone registration)

!DISCONNECT PHONE (disconnect phone)

!DELETE PHONE (delete phone)

If the phone is connected and paired The following functions can be operated.

!DISCONNECT PHONE (disconnect phone)

!DELETE PHONE (delete phone)

Notes

!The device name is set to PIONEER FLAP BT as default. You can change the device name in the initial setting. Refer to Editing device name on page 43.

!PIN code is set to 0000 as the default. You can change this code in the initial setting. Refer to Entering PIN code for Bluetooth wire- less connection on page 43.

Connecting and disconnecting a cellular phone

Using a cellular phone to initiate a connection

1 Display the connection menu.

Refer to Introduction of connection and regis- tration on the previous page.

2Use MULTI-CONTROL to select

BT HANDS FREE.

3Use MULTI-CONTROL to select a group. Push MULTI-CONTROL up or down to select a group.

NOKIA (Nokia)—STANDARD (standard)

#Normally select STANDARD. If the device of Nokia is not paired to this unit, select NOKIA.

#Push MULTI-CONTROL left or right to display a group name or an ID.

4Press MULTI-CONTROL to switch to

PAIRE FROM PHONE.

Push MULTI-CONTROL up or down to switch PAIRE FROM PHONE and SEARCH DEVICE.

5Select PAIRE FROM PHONE and then

press MULTI-CONTROL to ready for pairing. READY will be displayed.

6Use your cellular phone to establish connection.

PIN code is set to 0000 as the default. You can change this code in the initial setting. Refer to Entering PIN code for Bluetooth wireless con- nection on page 43.

While connecting, CONNECTING is displayed. If the connection is established, COMPLETED is displayed.

After connected, this unit automatically changes to PH. BOOK DL (phone book down-

load confirmation) display.

# If the connection fails, ERROR is displayed. In

this case, check the cellular phone and try again.

# If three cellular phones have already been paired, the pairing assignment selection display will appear. Select one assignment to pair the new phone. The newly paired phone overwrites the previously paired phone. The assignment se- lection operation is the same as Step 3 to 4 of Pairing a connected cellular phone on page 26 ex- cept for the operation below.

!Switching the BD address and device name

7Use MULTI-CONTROL to decide to download the phone book from your cellu- lar phone or not.

Push MULTI-CONTROL left or right to select NO (No) or YES (Yes).

Press MULTI-CONTROL to decide.

When you select YES, this unit changes to

PH BOOK DOWNLOAD and the download op- eration automatically begins. After complet- ing, DATA DOWNLOADED is displayed. According to the circumstances, this unit changes to PH BOOK TRANSFER. In this case, refer to step 4 on Transferring entries to the

phone book on page 33.

# When you select NO, the display reverts to normal.

24 En