Pioneer DEH-600BT Using this unit to initiate a connection, Connecting a paired cellular phone

	Section
Operating this unit	02

Using this unit to initiate a connection

1 Display the connection menu.

Refer to Introduction of connection and regis- tration on page 23.

2Use MULTI-CONTROL to select

BT HANDS FREE.

3Use MULTI-CONTROL to select a group. Push MULTI-CONTROL up or down to select a group.

NOKIA (Nokia)—STANDARD (standard)

# Normally select STANDARD. If the device of

Nokia is not paired to this unit, select NOKIA.

# Push MULTI-CONTROL left or right to display a group name or an ID.

4Press MULTI-CONTROL to switch to

PAIRE FROM PHONE.

Push MULTI-CONTROL up or down to switch PAIRE FROM PHONE and SEARCH DEVICE.

5Select SEARCH DEVICE and then press MULTI-CONTROL to start searching.

While searching, SEARCHING is displayed.

# If this unit fails to find any available cellular phones, NOT FOUND is displayed.

#If the connection fails, ERROR is displayed. In this case, check the cellular phone and try again.

#If three cellular phones have already been paired, the pairing assignment selection display will appear. Select one assignment to pair the new phone. The newly paired phone overwrites the previously paired phone. The assignment se- lection operation is the same as Step 3 to 4 of Pairing a connected cellular phone on the next page except for the operation below.

!Switching the BD address and device name

8Use MULTI-CONTROL to decide to download the phone book from your cellu- lar phone or not.

Push MULTI-CONTROL left or right to select NO (No) or YES (Yes).

Press MULTI-CONTROL to decide.

When you select YES, this unit changes to

PH BOOK DOWNLOAD and the download op- eration automatically begins. After complet- ing, DATA DOWNLOADED is displayed. According to the circumstances, this unit changes to PH BOOK TRANSFER. In this case, refer to step 4 on Transferring entries to the

phone book on page 33.

# When you select NO, the display reverts to

Operating this unit

6Use MULTI-CONTROL to select a device. Push MULTI-CONTROL up or down to select a device name you want to connect.

Press MULTI-CONTROL to select a device

name.

# Push MULTI-CONTROL left or right to switch the BD address and device name.

7Use your cellular phone to establish connection.

PIN code is set to 0000 as the default. You can change this code in the initial setting. Refer to Entering PIN code for Bluetooth wireless con- nection on page 43.

While connecting, CONNECTING is displayed. If the connection is established, COMPLETED is displayed.

After connected, this unit automatically changes to PH. BOOK DL (phone book down- load confirmation) display.

normal.

Connecting a paired cellular phone

1 Display the connection menu.

Refer to Introduction of connection and regis- tration on page 23.

2Turn MULTI-CONTROL to select

PAIRED PHONE.

# Push MULTI-CONTROL up or down to select a

desired phone.

# Push MULTI-CONTROL left or right to display the BD address, group and ID number.

3Press MULTI-CONTROL to start connec- tion.

While connecting, CONNECTING is displayed. If the connection is established, CONNECTED is displayed.

En 25