Section
02
Operating this unit
Non-RDS or MW/LW
1 2 3 4 5
6
1Band indicator
2Stereo (5) indicator
Shows when the selected frequency is being broadcast in stereo.
3LOC indicator
Shows when local seek tuning is on.
4Preset number indicator
5Signal level indicator
Shows the radio wave strength.
6Frequency indicator
1Press SOURCE to select the tuner.
2Press BAND to select a band.
Press BAND until the desired band is dis- played,
3To perform manual tuning, push
4To perform seek tuning, push and hold
The tuner will scan the frequencies until a broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
# If you push and hold
!Up to 18 FM stations, six for each of the three FM bands, and six MW/LW stations can be stored in memory.
1When you find a frequency that you want to store in memory press LIST.
2Use
Turn to change the preset number; press and hold to store.
The preset number you have selected will flash and then remain lit. The selected radio station frequency has been stored in memory.
3Use
Turn to change the station; press to select.
# You can also change the station by pushing
# If you do not operate the list within about 30 seconds, the display is automatically returned to the ordinary display.
Using the remote control
%When you find a frequency that you want to store in memory, press one of pre- set tuning buttons 1 to 6 and hold until the preset number stops flashing.
The number you have pressed will flash in the preset number indicator and then remain lit. The selected radio station frequency has been stored in memory.
The next time you press the same preset tun- ing button the radio station frequency is re-
called from memory.
# You can also recall radio station frequencies assigned to preset tuning numbers by pushing
Storing and recalling broadcast frequencies
You can easily store up to six broadcast fre- quencies for later recall.
12
En
