Switching the feature demo

2Press MULTI-CONTROL to switch the rear output setting.

Pressing MULTI-CONTROL will switch be- tween Rear SP :F.Range (full-range speaker) and Rear SP :S/W (subwoofer) and that status

will be displayed.

# When no subwoofer is connected to the rear

output, select Rear SP :F.Range.

# When a subwoofer is connected to the rear output, set for subwoofer Rear SP :S/W.

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 30).

!If you change this setting, subwoofer output in the audio menu return to the factory set- tings.

!Both rear speaker leads outputs and RCA rear output are switched simultaneously in this setting.

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON.

1Use MULTI-CONTROL to select Demonstration.

2Press MULTI-CONTROL to turn the fea-

ture demo on.

# To turn the feature demo off, press MULTI-CONTROL again.

Notes

!Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power.

!You can also turn on or off feature demo by pressing DISPLAY while this unit is turned off. For more details, see Feature demo mode on page 8.

Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.

!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjust- ment is possible.

!Sound from this system returns to normal when the muting or attenuation is can- celed.

1Use MULTI-CONTROL to select Mute.

2Press MULTI-CONTROL to switch the tel- ephone muting/attenuation.

Pressing MULTI-CONTROL will switch be- tween TEL ATT (attenuation) and TEL mute (muting) and that status will be displayed.

If you do not perform an operation within about 30 seconds, screen indications start to reverse, and then continue reversing every 10 seconds.

1Use MULTI-CONTROL to select Reverse mode.

2Press MULTI-CONTROL to turn the re-

verse mode on.

# To turn the reverse mode off, press MULTI-CONTROL again.

Note

You can also turn on or off reverse mode by press- ing BAND while this unit is turned off. For more details, see Reverse mode on page 8.

En 35