Before You Start
! | You can turn off the warning tone. See | Attaching the front panel | ||
! | Switching the warning tone on page 34. | 1 | Make sure the inner cover is closed. | |
You can turn off the face auto open. See | ||||
|
| |||
| Switching the face auto open on page 34. | 2 | Replace the front panel by clipping it | |
|
| |||
into place.
Important
!Handle gently when removing or attaching the front panel.
! Avoid subjecting the front panel to excessive |
|
shocks. |
|
! Keep the front panel out of direct sunlight and |
|
high temperatures. |
|
! A few seconds after turning the ignition |
|
switch to on or off, the front panel automati- |
|
cally moves. When this happens, your fingers | Resetting the microprocessor |
may become jammed in the panel, so keep | |
your hands away from it. | The microprocessor must be reset under the |
| |
| following conditions: |
Removing the front panel | ! Prior to using this unit for the first time |
1 Press and hold EJECT to open the front | after installation |
! If the unit fails to operate properly | |
panel. | ! When strange or incorrect messages ap- |
| pear on the display |
% Press RESET with a pen tip or other pointed instrument.
2Slide and remove the front panel to- ward you.
Take care not to grip it too tightly or to drop the front panel and protect it from contact with water or other fluids to prevent perma- nent damage.
RESET button
Section
01
English
About the demo mode
This unit features two demonstration modes. One is the reverse mode, the other is the fea- ture demo mode.
3Put the front panel into provided pro- tective case for safe keeping.
En | 7 |
