05Preparation
Attaching/detaching the PIONEER stand (for PRO-940HD only)
The
CAUTION
•If mounting the panel on a stand, use only the attached stand for this model. Other stand models are not authorized for this panel.
•Two or more people are required to assemble and install this unit.
Detaching the stand
1Loosen the two installation bolts ➀ using the enclosed hexagonal wrench.
Installation bolts ➀ (M8 x 30 mm: silver)
2Remove the two installation bolts ➁ using the same hexagonal wrench.
Installation bolts ➁ 
(M8 x 60 mm: silver) 
3Lift the Plasma Display from the stand.
•Keep the installation bolts ➀ and ➁ for reattaching the stand to the Plasma Display at a later date.
22
NOTE
•Install the panel on a flat, stable location to avoid warping the glass components.
Reattaching the stand
1Fit the stand’s support columns under the Plasma Display shown below. Slowly ease the panel down on the supports.
•Be extremely careful not to insert the stand supports into any part of the Plasma Display other than the stand insertion slots. If the panel is mounted improperly, the communication ports could be damaged or the stand could be warped.
Line up the column supports with the bottom of the Plasma Display .
2Bolt the Plasma Display to the stand at the points indicated by the arrows.
Installation bolts ➁ 
(M8 x 60 mm: silver)
3Tighten the installation bolts ➀ firmly using the enclosed hexagonal wrench.
Installation bolts ➀ (M8 x 30 mm: silver)
NOTE
•Install the panel on a flat, stable location to avoid warping the glass components.
•Insert the screws in the holes vertically.
•Do not tighten them with more force than necessary.
En
