![](/images/new-backgrounds/1130023/130023147x1.webp)
12Using External Equipment
Plasma Display (rear view)
Connecting control cables
Connect control cables between the Plasma Display and other PIONEER equipment having the logo. These control cables carry commands from a Pioneer device through its remote control to the remote control sensor on the Plasma Display.
After the CONTROL IN terminals have been connected, the remote control sensors on the device does not accept commands from the remote control. Point the remote control at the remote control sensor on the Plasma Display to operate the device.
NOTE
•Make sure that the power is turned Off when connecting cables.
•Connect all components before plugging cables into the panel.
CONTROL IN
OUT
About SR+
The CONTROL OUT terminal on the rear of the Plasma Display supports SR+. This terminal supports linked operations with a PIONEER AV receiver. SR+ includes functions such as input switch linkage operation and DSP surround display. For more information, see the Pioneer AV receiver’s operating instructions regarding SR+ support.
NOTE
•When connecting control cables, use the SR+ cable.
•When connecting one or more Pioneer devices, directly connect the Plasma Display and an SR+ supported Pioneer amplifier. Do not daisychain other equipment between the Pioneer units.
•When operating devices using SR+, volume on the Plasma Display is lowered temporarily.
74
CONTROL
IN
OUT
CONTROL
IN
OUT
When SR+ is not used:
Use mono sound control cables with mini plugs, no resistance (sold separately)
When SR+ is used:
Use the SR+ cable (sold as an option).
En